Mixing
Place about 70–80 % of the pre-measured clean water (depending on consistency required - refer to “Mix Ratio”) into a clean container and gradually add the whole bag of SikaGrout®-215 into it while continuously mixing. Add the remaining water and continue mixing until the desired consistency is obtained. Mix for 2 to 3 minutes with a slow speed drill and paddle (~500 rpm).

For large quantities mixing, the use of a forced-action mixer of rotating pan, paddle or trough type is preferred. Free fall mixers should not be used.

Application
Use SikaGrout®-215 for grouting only. After mixing, stir lightly with a spatula for a few seconds to release any entrapped air. The grout is then poured immediately into the prepared formwork.

When carrying out baseplate grouting, ensure sufficient pressure head is maintained for uninterrupted mortar flow. For formwork repair, the prepared formwork must be firmly in place and kept watertight.

When placing grout over a large area, it is important to maintain a continuous flow throughout. Work sequence must be properly organised to ensure an uninterrupted flow. In large areas, SikaGrout®-215 may be pumped using heavy duty diaphragm pumps. Screw feed and piston pumps may also be used.

45cm x 30cm x 10cm

FOR PAYMENT:
(1) Paymongo: Mastercard, VISA, GCash, Maya, Grab Pay
(2) Online Bank Transfer to our BDO, Metrobank, and BPI accountsFor more details, kindly check Accepted Modes of Payment

FOR SHIPPING:
(Customer Location) in Metro Manila (NCR)

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Metro Manila**
Lalamove/ Grab Pin: LPM Construction Supply and Wood Center Corporation

(Customer Location) in Pangasinan

(1) Rush – Same day Pick-up
(2) Regular Pick-up
(3) Pick-up/Delivery via Third Party*
(4) Delivery to Site locations in Pangasinan**
Lalamove/ Grab Pin: LPM Construction Supply PangasinanBrgy, Tayug-San Quintin Rd. Tayug,
Pangasinan, PH